The MPD8 is discontinued, and this information is for support and reference only. We are please to offer DCC Specialties' Jack Wabbit Quad, a 4 position stationary DCC decoder for the MP series motors.

The MPD8 is a stationary DCC Decoder designed to drive up to 8 MP series switch motors, it is available Assembled and Tested only.

 
Features:
Works with most DCC systems that support accessory decoders

Controls up to 8 MP Series Switch Motors

Provides 8 inputs
• For local turnout control.
• For occupancy sensors
• For turnout feedback sensors

Control up to 8 routes on your layout for yard throats and interlocking plants

The eight outputs of the MPD8 can individually be assigned any DCC accessory address from 1 to 2040. There are eight wired inputs available for local control.

Programming:
“Smart” programming is a term used to describe a method to program Configuration Variables (CVs) using switch addresses. This method is a much easier way to program CVs. With “Smart” programming, you can set the output addresses without using CVs.  See the MPD8 manual.

Specifications:

Board size: 2.75" X 4.25"

Draws .01A of DCC from your track power bus in idle, .3A max when operating 2 motors (2 seconds for the MP series motor to operate)